Tag Archives: Tree Removal Techniques

3 Removal Options for Tree Removal

When Removing Trees, common Techniques Used:

The cutter checks for the lean of the tree, defect in the trunk, cavities from previous pruning, and symmetry of the tree to see if the tree’ s weight is perfectly balanced or not. A notch also called a wedge i.e. a sharp cut to help direct the tree where to go is made. Using this the direction can be made a little left or a little right by cutting on either side of the tree. Another way of cutting down a tree is by climbing all the way up and remove little by little. Just set the crane, level it up, lower the crane ball to the climber and once he is tied up the crane can hoist him to the top of the tree to proceed with cutting off the limbs.

Do you know about all the ways you can cut down trees? Before hiring them, you need to know about all the possibilities on taking down a tree and then by careful analysis decide which one to choose.

Ground procedures and Wreckage Removal
Obviously, you ca n`t leave it there or it would be a mess. You better gather up some hard tough men for this kind of job since it requires lifting limbs and placing them on a truck, cutting long pieces into smaller ones so that they are easier to carry and also run the logs through the wood chipper later.

Get & pick Started
Get and pick a technique started.
By Cutting Down the Entire Tree
The cutter checks for the lean of the tree, defect in the trunk, cavities from previous pruning, and symmetry of the tree to see if the tree’ s weight is perfectly balanced or not. A notch also called a wedge i.e. a sharp cut to help direct the tree where to go is made. Using this the direction can be made a little left or a little right by cutting on either side of the tree.
Cutting the tree and climbing in Sections
Another way of cutting down a tree is by climbing all the way up and remove little by little. This method is preferred especially if your tree is near power supply line or any property. This process goes on and on until the whole tree is cut.

Using a Crane
I would say this is the safest of them all. It is practically more work for a crane and less for a human being. Just set the crane, level it up, lower the crane ball to the climber and once he is tied up the crane can hoist him to the top of the tree to proceed with cutting off the limbs.